Reasons For Damp Walls

Damp walls can be everyone’s nightmare. And being able to know the reason for this nightmarish experience can help avoid it in the future. There are many reasons for this and here we take a look at the most common reasons that most of us have experienced problem. Next time you experience this wet wall issue, you will know what to do. Read below to find out the reasons.

Leakages

One of the major reasons for the wet walls is the leakages. Rain water getting in between the walls is another major reason. Leakages due to improper roofing and also leakages for the pipes set within the walls have been identified as one of the major reasons. You will need to ensure that any leakages or even in some cases blockages are fixed immediately. Because if not you will face damp walls as an issue as well. This can lead to other problems within the house as well.

Damp down low

If you have crumbling paint, wet patches or even powdery deposits on the wall surfaces close to the floor, rising damp may be identified as the root cause for it. This usually occurs when a damp proof course is absent in masonry walls. Sub floor ventilation and poor drainage systems have also been identified as major causes for damp on the lower surfaces. Ensure that you have proper drainage systems and anti damp measures taken on the lower surfaces of the walls to avoid this problem.

Patches

There are instances when patches start to appear on the surfaces. These patches are generally the result of water getting in between the brickwork through cracks and gaps on the outer surface. If you find any gaps, especially on the exterior walls be quick to patch them up. You can also get advice on waterproofing for such walls that tend to get cracks and gaps from waterproofing services providers. If these patches are closer to a window, the water may be coming through the window panes or the frame. You will need to do a thorough check on them. It is always best to get good quality window frames for your homes.

Condensation

Condensation is when there is a lot of moisture in the rooms. When the steam comes in contact with the cold walls it causes wetness on the walls. Most of the time when you touch such walls you can feel the wetness on them. In order to avoid such a situation, you can fix an extractor fan. Most likely places would be the bathroom and the kitchen where there is a lot of steam emitted. So you can install an extractor fan in the kitchen and the bathroom beforehand to avoid this problem.

Writen by Ruy Naranjo